Bill of materials

Printed parts

1 Block 1 Lever

Note: Parts should preferably be printed in PETG, ABS or ASA as PLA may creep significantly over time.

Electronics

There are two board variants included in this repository, either can be used to assemble the InFiDEL. PCBs and electronic components can be easily ordered via the Kitspace project page as it can auto-fill carts and get pricing on PCBs and electronic components from common suppliers.

Choose one:

  • SMT control board (which is populated; Gerber files and component specifications are included)

  • THT control board

Also required:

  • Suitable programmer for ATTiny85 (eg USBtinyISP)

  • 1 SS495A linear hall effect sensor (or comparable)

Fasteners

  • 2 M3x8 screws (eg ISO 4762 M3x8)

  • 1 3x24mm pin (eg DIN 7 3x24mm, for mating lever to the block)

  • 1 3x16mm pin (eg DIN 7 3x16mm, for roller bearing in lever)

  • 1 3x18mm pin (eg DIN 7 3x18mm, for idler bearing in block)

  • 6 M3 threaded inserts

  • 1 M6x5 or M6x8 grub screw (eg ISO 4026 M6x5, for pre loading spring)

Pins may be replaced with screws or grubscrews, which may result in decreased precision.

Other hardware

  • 1 6x2mm magnet (eg N35)

  • 4 623 bearings (preferably 623-2Z / 623-ZZ)

  • 1 Ballpoint pen spring (or other soft 4mm spring)

  • Short length of PTFE tube

Calibration accessories

  • 1 1.5mm drill bit

  • 1 1.7mm or 1.8mm drill bit

  • 1 2mm drill bit

  • Calipers for verifying drill bit shaft diameter

Drill bits may be replaced with similar diameters. Measured diameter is to be written to firmware lookup table.